Braces medi bike

M.4s® comfort

4-point knee brace

 Medicinska specifikationer

Functional rigid brace with flexion / extension limitation

The M.4s comfort is a functional knee orthosis. The product is exclusively to be used for the orthotic fitting of the knee and only on intact skin.



Funktioner

Produktfördelar

  • Optimal stabilisation using 4-point principle

  • Safe collateral stabilisation by riged Frame

  • Extension and flexion limitation protects against damaging joint movements and relieves injured structures

  • Optimal immitation of Knee movement by using patented physioglide Hinge Technology

  • Limitations: extension limitation: 0°, 10°, 20°, 30°, 45°, flexion limitation: 0°, 10°, 20°, 30°, 45°, 60°, 75°, 90°, (120° only M.4s), immobilisation: 0°, 10°, 20°, 30°, 45°

Anvisningar för påtagning/utprovning

Open all the straps. Sit on the edge of a chair, pull the brace up the affected leg and flex your knee to 45°. Position the joints so that the centres of the hinges (extension wedges) are on a level with the top edge of the kneecap. Make sure that the brace is not twisted on your leg.
First fasten the lower front calf strap, then the upper back thigh strap. Keep your knee in a flexed position and push both joints towards the back of the leg.
Now fasten the lower back thigh strap. Make sure that you do not have the hinge joints positioned in front of the midline of the leg.
Now fasten the upper front calf strap. Then the upper back calf strap, and finally the front thigh strap.
Bend your knee slightly a few times and refasten the straps again in the order described above to prevent the brace slipping.

Anvisningar för användning

Only change the extension and flexion limits on instruction from your doctor or orthotist. In order to prevent hyperextension, always insert extension wedges or 0° wedges. The wedges define the exact excursion of the orthosis. In difficult soft-tissue conditions, e.g. where the soft-tissues are under compression, it may be necessary to insert the larger wedge to limit the joint movement to the desired excursion. In addition, make sure that the orthosis joints are correctly positioned: the middles of the joints should be level with the upper border of the patella. The joint must lie behind the midline of the leg.
Shaping the orthosis
When shaping the orthosis, please ensure that the joints stay parallel. This guarantees that the orthosis will function well and run easily and that there is no excessive wear.
Fastening the belt eyes
The belt eyes have been adequately fastened and are, to some extent, deliberately mobile. Please do not tighten the screws; they are tight enough. If you apply too much force, you can break off the screws.

Information

Standardfärger


Materialkomponenter

Avional, Velours, Polyester, PU foam


Tvättråd

You can wash the inner and condyles upholstery by hand using cold water and a mild soap, preferably a medi clean detergent. Do not bleach. Air dry. Do not iron. Do not dry clean. When used normally the brace is maintenancefree. However, after using the brace in water, the hinges can be lubricated using Teflon™ spray. Check regularly that the joint screws are secure, tighten them if necessary.


Storlekar


Storlekar

XS – XXL

Varianter

Left
Right

Medicinska specifikationer

Indikationer

  • Conservative / postoperative after cruciate ligament ruptures (isolated or with accompanying injuries)
  • Conservative / postoperative after collateral ligament ruptures with meniscus lesions
  • Conservative in the case of knee instability (isolated or combined)

None known at present

Liknande produkter